Ikelite Fiber Optic Converter for DS Strobes

The Fiber Optic Converter features heightened sensitivity for the most reliable fiber optic triggering of Ikelite DS strobes. This Converter is required for use with SEA&SEA or Nauticam housings with internal electrical-to-optical flash triggering devices. These devices translate the camera's electrical signals into a series of LED flashes which are much less bright than a traditional built-in camera flash.

Compared to the Fiber Optic Adapter (1st Gen), upgraded electronics make this Converter capable of accurately reading these signals for fast and reliable triggering with these devices. Like the original Fiber Optic Adapter (1st Gen), the Fiber Optic Converter is also compatible with any system where the camera's built-in flash can be seen by a fiber optic cord.

For remote optical slave triggering off another flash without a cable, consider the Optical Slave Converter, see below.

The Fiber Optic Converter automatically configures itself for compatibility with both pre-flash and non pre-flash camera modes. No setting of small switches or confusion over number of pre-flashes. Simply turn on your strobe and take one picture to configure.

This adapter is a manual exposure (non-TTL) trigger only. The strobe's output may be adjusted using the manual power settings built into the strobe (varies by model).

An individual Fiber Optic Converter is needed for each strobe. Use of two strobes requires two Fiber Optic Converters. The Fiber Optic Converter supports DS50, DS51, DS125, DS160 and DS161 strobes.

• Ikelite 4501 Fiber Optic Coiled Cord
• INON Optical D Cable "Non-wireless type" L-Connector
• Sea&Sea Fiber Optic Cable (L-type) Product No. 50107
• Olympus UW Fiber Optic Cable PTCB-E02
• Nauticam Optical Fiber Cable No. 26211 Nauticam to INON
• Nauticam Optical Fiber Cable No. 26212 Nauticam to Sea&Sea

• Converter
• Silicone lubricant

• 1.1 diameter x 2.7 in (28 x 69 mm)
• Weighs 1.6 oz (45 g)
• Depth rating 300 ft (90 m)